2024年2月8日 · Then the pull string piñata, each kid lines up and takes a turn pulling one string until the bottom falls out... it was very anti climatic. Yet my friends son got his turn, grabbed all the strings and pulled. Chaos erupted like it had when we were kids, racing to grab the most candy. Is there anything else I should prepare to be disappointed by?

2022年8月2日 · That way, when you tie the wire off, you can just pull it through and still be able to get to the wire pull string from either end when done, so you can immediately pull the wire pull back through. Yeah you could use a 20 ft. pull, but then depending on where it is you might have to first pull it towards you, then tie the wire to it.

Usually the adjustment is at the base of the neck in the sound hole. Remove strings, turn the allen wrench or other approved tool a very small turn clockwise and then put strings back and see how it feels. Very small adjustments every few days until it is to your taste. But turn it too much and it could break the truss rod. BE WARNED!!!!!

2020年6月17日 · 365 votes, 52 comments. 3.4M subscribers in the homeautomation community. A place to share and discuss all things related to home automation.

2022年4月23日 · Keep using the palm of your picking hand to mute lower strings, and get both hands working in conjunction to mute every string you’re not playing. It all feels a bit awkward at first, but like anything else it becomes comfortable and then it becomes internalized habit.

2022年10月15日 · Multiple strings can be pulled at once, if you want to make a partial a full success, or a failure a partial (etc etc). Usually once someone starts to take advantage of conditions/strings, the other players will follow suit- and if a condition becomes stale, you can remove it, or offer opportunities for the player to, ie: "If you delay your ...

2023年3月12日 · No, do not use the cords. Remove both strings. Take it apart and you will see that the strings are both wrapped around a drum and the from turns a shaft. Remove the drum and replace it with a gear motor that directly turns the shaft. You REALLY want an encoder on the motor so you can measure the motion.

The general rule of thumb being that you bend the thinner strings up and the thicker strings down. You can get away with the opposite to a certain extent, but the B and high E strings don't have a lot of space to go bending down and same for the Low E and A strings with bending up.

2022年10月7日 · "It pulls the strings and makes them ring" sounds to me like a description of operating church bells. This might be related to Spamton's fascination with Angels and Heaven. The only real flaw I can find with this is the church in Hometown doesn't appear to have a bell.

2023年10月7日 · Hitting the strings really hard is a waste of effort and energy, the goal is to make the string vibrate; but it's already under constant tension, so just quickly moving to the fret, or getting your finger off of the sting will let it resonate freely without being dampened by your finger.