Swash Plate Pump Design - Engineering Stack Exchange
A pump can be built with just one cylinder. Sealing a pressurized and noxious gas is harder than sealing hydraulic oil that just bleeds into a sump and is piped back to a tank. The energy wasted in compression makes this a bad idea in gasses. So go with a fixed cylinder that can be sealed and rotate the swashplate. plate. $\endgroup$ –
Rotating Swashplate on Piston Pump - Engineering Stack Exchange
2020年1月28日 · Rotating Swashplate on Piston Pump. Ask Question Asked 4 years, 11 months ago. Modified 4 years, 11 months ...
Mechanisms to convert linear motion to rotation
Swashplate also Axial Piston Pump. Wheel on a surface. While this is often a system such as a car and a road, it can also be built into mechanisms such as material conveyance rollers. Belt is used in conveyors and 3D printers. Chain also used in conveying. Also Rigid chain actuator. Pulley and Block and Tackle
aerospace engineering - Questions about helicopter rotors ...
2016年12月30日 · Considering that the helicopter's forward direction is the y-axis, the rear rotor should deliver torque, but the thrust created by the main rotor is connected to a swashplate so the thrust is not directly orthogonal. The main rotor can tilt into the y-axis in order to accelerate forward and vice versa. Just my own speculation. Check out this page:
How to make a cyclorotor? - Engineering Stack Exchange
2020年4月12日 · Stack Exchange Network. Stack Exchange network consists of 183 Q&A communities including Stack Overflow, the largest, most trusted online community for developers to learn, share their knowledge, and build their careers.
What does the torque curve of an engine mean?
2018年8月1日 · to produce a torque curve, the throttle is opened, the load increased, the throttle is opened more, the load is increased more, etc., etc. until the throttle is wide open- then the torque measurement is made. then the load is decreased slightly, which causes the RPM to increase slightly, and the torque is measured again. the process of decreasing the load …
How does a helicopter hover - Engineering Stack Exchange
2020年8月29日 · I understand that there is a second rotor that is used to counteract the angular momentum and also the use of swashplate to direct the helicopter forwards and backwards. Assuming the angular momentum of the main rotor is not an issue, Is there a sensor on the helicopter that can detect if it is not upright?
pressure - Using a Threaded Rod and Internally Threaded Tube as …
2021年2月4日 · $\begingroup$ @Brian, good, if it never sees boiling temperatures that will make more sealing options possible. At 20bar I think it would be a good idea to purchase a pump rather than designing one with the goal of making it cheaper than anything you can buy, with the possible exception of a piston or syringe type.
How do we specify among a shim, spacer, and washer?
2017年5月30日 · The three terms specify the function of the component, not its size. A shim is a component used to fill up an unwanted gap.
mechanical engineering - What is the difference between a piston …
My research has found a Quora link and another source giving two different, albeit not contrasting, definitions. Also, as far as I have seen, looking up "plunger compressor" also refers me to pumps...